This product with our exclusive adjustable bolt on bracket, is an easy way (no welding required) to upgrade a trailer from a standard 2,000 lb tongue jack (on the front of the tongue) with a 7,000 lb rated Drop Leg Jack, you pull a pin at the bottom and the center leg drops down then you re-pin it, then crank it to lift the trailer, it is faster , it lifts the trailer higher ( no using unsafe boards stacked under the jack ) . The design of our bracket enables easy no weld clamp on installation on trailer tongues 2” wide , from 3” tall , up to 10” tall just by sliding the top bracket into position.
The Condor Aluminum Wheel Chock is versatile, light weight, and compatible with etrack.
- Compatible with etrack mounting (adapters not included)
- Adjustable cradle fits ALL bikes from dirt bikes and sportbikes, to cruisers and heavy touring bikes, and anything in between, up to 3,000 lbs.
- Works on front and rear tires from 14″ to 22″ and 80mm to 230mm.
- Made of light weight aluminum, weighing only 30 lbs., and folds down for easy storage.
Introducing the new patent pending product, THE INSTANT OUTLET.
- You can now install this single unit 15 amp input , and duplex interior 15 amp GFI outlet in less than 10 minutes.
- This device saves hours of labor, you do not need to cut separate exterior, and interior rectangular holes, and install separate boxes.
- You do not need to wire anything, it is all pre-wired and assembled.
- All you need to do is drill a 4 1/2” hole with a hole saw, being careful to avoid wall studs and wires inside the wall.